|
|
|
|
|
|
|
|
|
|
|
Bushing for transmission input shaft. Please specify the correct inside diameter or transmission needed.
|
|
OM617 Motor Mount for vehicles using stock factory rubber MB mounts for installation (2-per car).
|
|
|
|
|
|
|
|
|
|
|
|
|
OM617 EGR Kit, used on MB turbocharged diesel engines. Will allow EGR to be removed to avoid carbon / oil build-up in the engine intake system.
|
AMC Flexplate (3-pcs.) Shim Kit, used on the MB204 and MB206 automatic transmission adapter kits. This allows the flexplate to be properly shimmed between the crankshaft adapter and flexplate. Stainless Steel material.
|
GM Flexplate (3-pcs.) Shim Kit, used on the MB211 automatic transmission adapter kits. This allows the flexplate to be properly shimmed between the crankshaft adapter and flexplate. Stainless Steel material.
|
|
|
|
|
|
|
|
|
|
|
|
|
GM Flexplate (3-pcs.) Shim Kit, used on the MB212 automatic transmission adapter kits. This allows the flexplate to be properly shimmed between the crankshaft adapter and flexplate. Stainless Steel material.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
OM617 Universal Fuel Shutoff Kit for vehicles with MB vacuum fuel shutoff on injection pump.
|
OM617 Universal Motor Mount set for vehicles with parallel frame rails. Uses stock rubber MB mounts for installation, which can be adjusted from left to right on MB106 motor mount. Height is adjustable from stock to 6" lift kit. Can be used on parallel frame widths from 24-1/2" to 31". Mounts are reversable to be used as a pocket or a shelf mount. Note: there are 2 different engine mount arm lengths on OM617 engines depending on model of car engine was removed from.
Use these mounts work for all CJ5 CJ6 CJ7 CJ8 and YJ Wranglers 1987-1995 Will not work with Jeep Cherokee XJ, Commanche, TJ or JK....
|
OM617 Exhaust Kit, pre-bent HD 2-1/4" pipes for maximum firewall clearance. Stainless steel flex coupler can be mounted in several locations, allows variable height and length for custom headpipe. Lower bent pipe overall length is 48". Note: Welding and Cutting is required.
|
|
|
|
|
|
|
|
|
|
|
OM617 Motor Mount set for 1986 - 2001 Jeep Cherokee and Comanche. Height is adjustable from stock to 6" lift kit. Bolts into unibody frame in existing holes. Frame perches are reversable to be used as a pocket or a shelf mount (perch welding is required). Sold as set 1 required per vehicle.
Will not work with Jeep Grand Cherokee...ZJ
|
OM617 Motor Mount set for for 1997 - 2006 TJ Jeep Wranglers. Height is adjustable from stock to 6" lift kit. Frame perches are reversable to be used as a pocket or a shelf mount.
Will not work with Jeep Cherokee XJ, Commanche, JK....
|
|